Instructions / Assembly

14621 REV 10-22-15
LIFETIME WARRANTY. Please register at www.ezaccess.com/warranty-satisfaction.
CE Technical Files kept at: V. Guldmann A/S, Grahan Bells Vej 21-23A, DK-8200 Aarhus N, Denmark
© EZ-ACCESS
®
, a division of Homecare Products, Inc. All rights reserved.
All text and images contained in this document are proprietary and may not be shared, modified,
distributed, reproduced, or reused without the express written permission of EZ-ACCESS.
Instructions
SUITCASE
®
SINGLEFOLD GF Ramp
IMPORTANT INFORMATION
Rated load is 660 pounds. Never exceed rated load.
Read and follow all labels, instructions, safety and
maintenance information before use.
For additional care, use or safety information, or to obtain
replacement copies, please visit www.ezaccess.com.
To select the ramp length, an incline chart is provided on the
reverse side of this document. However, it is intended only
as a guideline. Refer to your equipment's (wheelchair or
scooter) Owner Guide for the proper degree of
incline/decline and chair direction before attempting ramp
use. Never exceed its recommendations.
Do not use if ramp is damaged or unstable.
For wheelchairs and scooters only (not intended for
commercial use).
Ramp may be slippery when wet or icy.
Use only if sufficient maneuvering room is available at both
ends of the ramp to assure safe travel when entering and
exiting the ramp.
Use ramp only with a qualified helper and always use your
lap belt.
Ensure top lip transition (labeled TOP) is secure before
using ramp. To prevent ramp from becoming dislodged
during use, ensure that the top lip transition fully overlaps
and is in full contact with the resting surface (FIG. 1).
The supporting surfaces need to be substantial and of sound
construction.
Move and keep wheels within the yellow lines of the ramp
curb.
Be sure only the wheels of the wheelchair contact the ramp
surface. Other parts may cause damage to the anti-slip
surface.
Store ramp indoors after use.
Store ramp upright when not in use.
INSTALLATION
1. Ramp is shipped fully assembled.
2. Place ramp on landing in the folded position, making sure
that the top lip transition (labeled TOP) is resting securely on
the landing (FIG. 2).
The “TOP” label is placed on the underside of the
29 & 35-IN ramps, and on the outer curb of the 51,
67, & 85-IN ramps.
The useable ramp surface has an anti-slip
treatment. Do not mistake the surface for the back.
3. Unfold ramp and center on landing (FIG. 3).
4. Ensure top lip transition is secure before using ramp (FIG. 1).
SAFETY & MAINTENANCE
Regularly check ramp for damage. Keep ramp surface clear of ice,
snow, dirt, leaves, and other debris. For snow/ice, remove
accumulation and sweep the surface clean. To remove dirt, leaves,
and other debris, sweeping the surface or using a garden hose will
usually suffice, but, if needed, use a damp cloth or soft brush with
non-alkaloid detergent and water. Rinse well and use extra caution if
ramp surface is wet.
OPTIONAL ACCESSORY
Facilitate the handling and
transportation of the 29-IN
SUITCASE
®
SINGLEFOLD GF
Ramp with the optional Carry
Bag. This handy accessory
safely fits on the back of a
wheelchair.
FIG. 1
FIG. 2
FIG. 3

Summary of content (2 pages)