Instructions / Assembly

Instructions
TRANSITIONS
®
Angled Entry Plate
Available in 8-, 10-, and 12-inch lengths
13799 REV 05-12-15
LIFETIME WARRANTY. Please register at www.ezaccess.com/warranty-satisfaction.
CE Technical Files kept at: Enable Access, Marshmoor Works Great North Road, North Horth Mymms Hatfield, AL9 5SD, UK
© EZ-ACCESS
®
, a division of Homecare Products, Inc. All rights reserved.
All text and images contained in this document are proprietary and may not be shared, modified,
distributed, reproduced, or reused without the express written permission of EZ-ACCESS.
IMPORTANT INFORMATION
Rated load is 700 pounds, 350 pounds per caster or wheel.
Never exceed rated load.
Read and follow all labels, instructions, safety and
maintenance information before use.
For additional care, use or safety information, or to obtain
replacement copies, please call 1-800-451-1903 or visit
www.ezaccess.com.
Do not use if ramp is damaged or unstable.
For wheelchairs and scooters only (not intended for
commercial use).
Ramp may be slippery when wet or icy.
Use only if sufficient maneuvering room is available at both
ends of the ramp to assure safe travel when entering and
exiting the ramp.
Use ramp only with a qualified helper and always use your
lap belt.
It is important that you refer to your equipment's
(wheelchair or scooter) User Guide for the proper degree of
incline or decline and chair direction before attempting
ramp use. Never exceed its recommendations.
GETTING STARTED
1. Ramp is shipped fully assembled.
2. Use the chart below to view the different rise ranges:
Size
Maximum Rise
8-IN
1-5/16”
10-IN
1-5/8”
12-IN
2”
FASTENING PLATE TO LANDING OR THRESHOLD
The Transitions Angled Entry Plate must be fastened
to the landing or threshold before use.
Use the two pre-drilled holes in the top of the ramp
to fasten to the landing or threshold. Wood screws,
sheet metal screws, or concrete bolts may be
necessary, depending on the application.
1. ATTACHING TO WOOD
1.1 Fasten the Angled Entry Plate by installing one
1/4” x 1” self-drilling stainless steel screw
(supplied) through each hole as shown.
2. ATTACHING TO CONCRETE
2.1 Use the two pre-drilled holes in the top of the
Transitions Angled Entry Plate as a template to
mark the positions to drill.
2.2 Using a 1/4” masonry bit, drill two holes at the
marked locations. Drill to a depth specified by the
pin drive anchor manufacturer’s instructions.
2.3 After drilling, make sure that the holes are free of
any residue and/or debris.
2.4 Align the Transitions Angled Entry Plate over the
drilled holes.
2.5 Install 1/4” x 1 1/2” pin drive concrete anchors (not
supplied) into the holes per the pin drive anchor
manufacturer’s instructions.
SAFETY & MAINTENANCE
1. Regularly check ramp for damage and tighten any loose
fasteners.
2. Keep ramp surface clear of ice, snow, dirt, leaves, and
other debris. For snow or ice, remove accumulation and
sweep surface clean. To remove dirt, leaves, and other
debris, sweeping the surface or using a garden hose will
usually suffice. If needed, use a damp cloth or soft brush
with non-alkaloid detergent and water. Rinse well and use
extra caution if ramp surface is wet.