Installation Instructions

Unfold each frame, setting aside (2) frames
to be used as end walls. For gusset plates
cut 1×4 pine boards 6" long: 16 for an 8'
building; 24 for a 12'; 32 for 16'; and 40 for
a 20'. Apply gusset plates on each side of
the top and bottom fold locations. Use (4)
8d nails on each gusset plate. Frames used as end walls require only one gusset plate on the interior
sides opposite the metal plates. See diagram.
STEP 1. GENERAL
STEP 2. INVENTORY
STEP 3. FRAME PREPARATION
E-Z BUILD BARN GUIDE
12'×12' • 12'×16' • 12'×20'
Prior to beginning construction, the area
selected for the shed location must be level
and cleared of obstructions.
Shown with rollup door.
Shown with vinyl siding, optional
octagon window and rollup door.
PLEASE NOTE: This shed construction aid is intended solely to provide general knowledge as to one of the ways
a shed may be constructed. We suggest you check with your local building ofcials regarding site location, permit
procedures, safety regulations and specications of materials used to construct your new storage shed. Builders
who utilize this aid must proceed at their own risk and are solely responsible for complying with all building codes
which pertain in their community. Midwest Manufacturing hereby disclaims all liability for any damages whether
consequential, incidental, special or otherwise, which may result from following this do-it yourself aid.
COPYRIGHT BY Midwest Manufacturing 2018 www.midwestmanufacturing.com
Separate all lumber, hardware, etc. into
individual stacks of like items.
12' Gambrel
Frame
8"
2×4 Roof and
Sidewall Frame
Members
Treated 2×4 Bottom
Frame Member
1×4×6" gusset
plate at top and
bottom fold
locations
12'0"
1½"
1½"
67
3
⁄
16
"
45¾"
71¾"
144"
132
15
⁄
16
"
75
11
⁄
16
"
BUILD
You can construct your
own E-Z frame barn
with the help of this
step by step guide.
North American
softwood
dimensional
lumber sizes:
Nominal Actual
in × in
1 × 4 ¾ × 3½
1 × 6 ¾ × 5½
2 × 4 1½ × 3½
2 × 6 1½ × 5½