Installation Guide

Terms and Conditions of Usage
TERMS AND CONDITIONS. Upon breaking the seal attached to the installed EZ-Connect™, you expressly agree
that usage is restricted and subject to the following terms and conditions (“Terms and Conditions”).
INSTALLATION AND CARE OF PROPERTY. The EZ-Connect™ unit must be installed by an Approved Installer
and may not be removed or modified by anyone other than an approved installer. An approved installer is defined as
a licensed electrician or a technician approved by your local electric utility (“Utility”). As a user of EZ-Connect™, you
further agree to follow the EZ-Connect™ start-up procedure provided in this Operating Manual, incorporated herein
by reference. At all times, the EZ-Connect™ unit shall be used solely for the purpose intended, in accordance with
the Instructions and “Safety Tips” contained in this Operating Manual, incorporated herein by reference. You
understand that any installation, removal, or modification by anyone other than an approved installer is dangerous
and is expressly prohibited under the terms of this agreement.
DELIVERY AND ACCEPTANCE OF PROPERTY. Within Thirty (30) days of its installation, you are required to test
the EZ-Connect™ unit with a generator. Written notice of any defects or concerns with the operation of the EZ-
Connect™ unit must be received within Forty-Five (45) days from the installation date of the EZ-Connect™ unit by
Global Power Products at 225 Arnold Road, Lawrenceville, GA 30044 specifying any defects, or it shall be
conclusively presumed that you have accepted the EZ-Connect™ unit and found it to be in good operating
condition. This provision shall not be applicable to latent defects of which you could not reasonably be aware.
SAFETY. You understand and agree that once the EZ-Connect™ unit is installed, it is the only safe and allowable
method for connecting a generator to your home. You grant the utility company the right to enter the site where the
EZ-Connect™ unit is installed, to temporarily disconnect the generator, and to physically “lock out” the EZ-
Connect™ unit at any time if the Utility determines that a potential hazard exists and that such temporary action is
necessary to protect the utility’s electric system, its customers, and/or its employees.
INSPECTION, REMOVAL AND REPAIR. You acknowledge that the EZ-Connect™ unit shall not be removed or
removal by anyone other than an approved installer. If the EZ-Connect™ unit requires inspection, removal, repair, or
replacement, immediately contact an approved installer to request that the EZ-Connect™ unit be removed. Contact
Global Power Products at 225 Arnold Road, Lawrenceville, GA 30044, or call at 1.800.886.3837 to receive
instructions on how to have the EZ-Connect™ unit repaired and/or replaced.
CLAIMS AND EXPENSES. You expressly agree to hold the utility, the authorized EZ-Connect Reseller, and Global
Power Products harmless from any and all claims, costs, expenses, damages, and liabilities, including reasonable
attorney’s fees, resulting from, or alleged to be caused by, directly or indirectly, use, operation, or failure of the EZ-
Connect™ unit.
TERMS TO BE EXCLUSIVE. You acknowledge that the Terms and Conditions constitute the final and entire
agreement regarding the use and purchase of the EZ-Connect™ device.
GOVERNING LAW. It is expressly understood and agreed that the Terms and Conditions are to be interpreted
according to the laws of Georgia.
Copyright © 2018 by Global Power Products, Inc. All rights reserved
No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, recording, or
by an information storage or retrieval system without the prior written permission of Global Power Products unless such copying is expressly permitted
by federal copyright law.
WARNING!
Read and understand the instructions contained herein-after
before attempting to unpack, assemble, operate, or maintain
this equipment.
Hazardous voltages are present inside the EZ-Connect
enclosure that can cause death or severe personal injury.
Follow proper installation, operation, and maintenance
procedures to avoid these voltages.
The EZ-Connect transfer switch equipment covered by this
instruction book is designed and tested to operate within its
nameplate ratings. Operation outside of these ratings may
cause the equipment to fail resulting in death, serious bodily
harm, and/or property damage. All responsible personnel
should locate the door mounted equipment nameplate and
be familiar with the information provided on the nameplate.