Installation Guide

1
Section 1 – General Information
1.1 Introduction
Thank you for purchasing a Global Power Products EZ-Connect manual transfer switch to safely connect a
portable generator to your home during a power outage. This manual has been prepared especially for the
purpose of familiarizing personnel with the design, application, installation, operation and servicing of the
applicable equipment. Carefully read all instructions before using EZ-Connect. This will help to prevent
accidents or damage to equipment that might otherwise be caused by carelessness, incorrect application, or
improper procedures. Product features include:
 Generator and Utility Mains mechanically interlocked preventing utility or generator power back feed.
 Flexibility of selecting the appliances you want to run from your home’s breaker panel, up to the capacity of
your generator.
 Mechanical lockout that safely prohibits power from any source when servicing device.
 Type 3R enclosure which is rated for outdoor or indoor installations.
 Rated for up to a 200 Amp service.
1.2 Equipment Description
The EZ-Connect manual transfer switch is used for transferring critical electrical loads from a UTILITY
(NORMAL) power source to an ALTERNATE (GENERATOR) power source. The transfer switch prevents
electrical back-feeding between the UTLITY and ALTERNATE sources. For that reason, electrical codes
require a transfer switch in all standby electric system installations.
1.3 EZ-Connect Enclosure
The standard switch enclosure is National Electrical Manufacturer’s Association (NEMA) and UL 3R type
enclosure primarily provide a degree of protection against falling rain and sleet; undamaged by the formation of
ice on the enclosure.
1.4 Important Installation Information
A model label is permanently affixed to the transfer switch enclosure. Use this transfer switch only with the
specific limits shown on model label and on other decals and labels that may be affixed to the switch. This will
prevent damage to equipment and property.
You MUST have this information should the unit need repair or replacement. Please complete the information
from the model label affixed to EZ-Connect and keep this information for future reference
Installation Date:
Model Number:
Serial Number:
EZ-Connect shall not be removed or uninstalled by anyone other than a licensed electrical contractor. If the
EZ-Connect requires inspection, removal, repair, or replacement, immediately contact the licensed electrical
contractor to request that the EZ-Connect be removed. Once the unit is removed, contact Global Power
Products at 225 Arnold Road, Lawrenceville, GA 30044, or call at 1.800.886.3837 to receive instructions on
how to have the EZ-Connect unit repaired and/or replaced.