Owner's manual

SATA HDD Duplicate Controller Manual

3.8.13 Quick Compare

This option is used to set the size of each comparison unit.

8-13. Setup

Quick Compare

Press ENT to enter the following figure. The default is Off. Use the Up and Down arrow keys to

choose 1 Byte/1K/10K/100K/1MB/10MB/100 Mbytes. (In order to improve the accuracy of pure

data can maintain the default settings.)

Quick Compare

Off

3.8.14 Copy with Size (for 1-11 HDD Duplicator only)

This option is used to set the source hard disk with the target hard disk the same capacity after a

copy operation.

8-05. Setup

Copy with Size

Press ENT to enter the following figure. The default is Off. Use the Up and Down arrow keys to

choose On.

Copy with Size

Off

Attention: This is Function for 1-11 HDD duplicator only.

3.9 USB Mode (for 1-1 HDD Duplicator only)

This option allows a copy controller connected to the host computer's USB port to be operated

from the PC.

Choose option 7 from the menu:

7. USB Mode

Press ENT and the LCD will display the corresponding information as shown below.

Switch USB Mode?

Use the Down arrow to select YES then press ENT again to switch to USB Mode. The LCD will

display the following info.

USB L.H Mode

D1:HDD D2:HDD

Now press ENT to switch to stand-alone mode. The LCD will display the following info.

Copy Mode

Attention: This is Function for 1-1 HDD duplicator only.