Manual

II.FunctionIntroduction
1. Copy
The2CUSBPortableUSBDuplicatorcopiesdatafromsourceFlashdevicestotargetFlashdevices.The
defaultsettingcopyareais“Da t aOnly”.Ifyouwouldliketochangethecopyareafrom“DataOnly”to
“WholeHDD”or“AllPartitions”,pleaserefertofunction[5.1CopyArea]toselectothercopymodes.

Copysteps:
InsertsourceFlashDevice(Master)andtargetFlashdevicesintoduplicatorÆSelect[1.Copy]ÆPress
[OK]ÆTheLCDwillshowthenumberoftargetFlashdevicesdetectedandPress[OK]tostart
copyingÆCopyprocessingÆCopyfinishedÆPress[ESC]tofinishcopy.




In<DataOnly>Mode:

**DonotremoveanyFlashdevicewhileitisprocessing.

**Itisstronglyrecommendedthatthetargetdevicesandsource(master)havethesamecapacity.

**Aftercopying,thetargetflashdevicedataandformatwillbethesameasthesourceflashdevice.
Originaldataontargetflashdeviceswillnolongerexist. 

**Whenthecopyingprocessisinprogress,thegreenLEDwillflash.Whentheprocesshasfinishedthe
greenLEDwillstopflashingbutwillremainilluminated.IfanerroroccurstheredLEDwillilluminate.

2. Compare
ThisfunctionisusedtocheckifthedataonthesourceFlashdeviceisidenticaltothecopiedFlash
devicesafterduplication.

CompareSteps:
InsertFlashdevicesintoduplicatorÆSelect[2.Compare]ÆPress[OK]ÆCompare
ProcessingÆComparefinishedÆPress[ESC]tofinishcompare.
5