Installation Guide

53
4 6
Connect the outlet hose with pull-down hose
Confirm the bushing return to original state .
Set the weight on the appropriate location of the pull-down hose , tighten the screws .
1
2
3
Pull the spray header down until appropriate location .(See the detail A)
Use the wrench to tighten the lock nut.
Connect to water supplies (hot and cold angle valve).
Pull the hose assembly out of the spout and be sure to hold the end of the hose down into the sink.
Turn faucet handle to be full on mixed position.
Turn on hot and cold water supplies , and flush water lines for one minute.
Turn off faucet handle, reinstall the spray header , check all connections at arrows for leaks.
1
A
1
2
2
1
2
3
There should be a gap here
2
1
2
3
4
1
3
1
2
3
1
2
3
4