Instructions / Assembly

ManualsBrandsEZ-FLO ManualsBathMetro Single Hole Single-Handle Bathroom Faucet with 50/50 Pop-Up in Brushed Nickel

Single Control

Bathroom Faucet

Before You Begin

Check to make sure you have the following:

Silicone

Sealant

10667

10669

Tools and Supplies

You will need the following to install your new faucet:

Pipe

Tape

Adjustable

Wrench

With Pop-Up

1 Screw & Plug A66D806

2 Metal Handle A069984

3 Handle Trim Cap A103121

4 Adjusting Ring A104041

5 Ceramic Disc Cartridge A507169N

6 Aerator 1.2gpm A553058N

7 Cover Plate Assembly A66F324

8 Mounting Hardware A663221-H

9 50/50 Pop-Up Assembly A505219-P

Phillips

Screwdriver

This product is engineered to meet the

EPA WaterSense flow requirement. The

flow rate is governed by the aerator. If

replacement is ever required, be sure to

replace it with a WaterSense compliant

lavatory faucet aerator to retain the water

conserving faucets of this faucet.

Summary of content (4 pages)

PAGE 1
0667 10669 Single Control Bathroom Faucet With Pop-Up Before You Begin Tools and Supplies You will need the following to install your new faucet: Check to make sure you have the following: This product is engineered to meet the EPA WaterSense flow requirement. The flow rate is governed by the aerator. If replacement is ever required, be sure to replace it with a WaterSense compliant lavatory faucet aerator to retain the water conserving faucets of this faucet.
PAGE 2
Faucet Installation Shut off main water supply before installation. 1 Shut off hot and cold water supply to faucet or turn off main water supply. 2 Remove lock nut. Install faucet through center hole. 2 4 Connect and tighten the water supply line nuts by using two adjustable wrenches (avoid twisting or kinking). 5 After installing faucet, remove aerator and turn on water to remove any left over debris. Reassemble aerator and tighten. 3 Unscrew screws on lock nut.
PAGE 3
Pop-Up Drain Installation Stopper 1 2 Cartridge 4. 5. 3 Drain collar Rubber washer 4 5 Lock nut 2 Place a ring of silicone sealant beneath the lip of the drain collar (3) and place it in the opening of the sink. Press down firmly to secure the drain collar (3). 1 Remove the rubber washer (4) and lock nut (5) from the drain assembly. 3 Tighten the rubber washer (4) and lock nut (5) onto the drain collar. 4 Connect tail piece on pop-up drain to waste outlet (not included).
PAGE 4
Troubleshooting Guide Minor problems often can be fixed without a plumber. Before doing any work on the faucet, shut off water supply and close stopper or drain to avoid losing small parts. Problem Cause Leak from under handle Damaged cartridge Solution .Remove handle. Replace cartridge. Uneven water spray Clogged aerator Remove aerator. Clean or replace aerator if necessary. Leak from around aerator Bad aerator seal Remove aerator. Check to see that seal is flat and undamaged.