Instructions / Assembly

Railing Assembly and Installation

STEP 2:

1. Place predrilled bottom channel (A) on its side using non-abrasive work

surface. Protect the painted surface from scratching.

2. Position one picket (B) above bottom channel aligning the predrilled holes.

3. Start both 1 ½” fasteners (C) thru bottom channel halfway into picket,

and then tighten fasteners down fully. Tighten fasteners until flush – DO

NOT OVER TIGHTEN.

4. Repeat these steps until all pickets are secured.

STEP 3:

1. Place predrilled top snap (D) on the opposing side of pickets.

2. Loosely fasten top snap to the first and the last picket making sure the

predrilled holes are aligned correctly. Next, loosely fasten a picket near the

center. Make sure not to tighten until all pickets are in place.

3. Once the top snap is loosely fastened to all pickets, stand the EZ Handrail

upright and secure all pickets – Tighten fasteners until flush – DO NOT

OVER TIGHTEN.