Instructions / Assembly

PVC INTERLOCKING LINER PANEL
Technical & Install Guide
The last panel may need to be inserted into
the slot of the Inside Corner Cove trim with
a sheet rock putty knife. Make sure the last
panel is cut ¼” (6mm) less than the opening
width
to allow for panel expansion.
If you are mounting a heavy object to the
wall such as an electrical box, use plastic
spacers to prevent the panel from being
crushed if the screws are overtightened.
The spacer is just a little thicker than the
panel. Drill a 1” (25mm) hole into the panel
and insert the spacer into the hole.
The inner hole of the spacer can now
receive any bolt or screw up to ½” (12mm)
in diameter. This will keep the heavy object
from hitting the PVC wall panel.
Note: Account for expansion when installing in cold
temperatures, ensure you have the correct stainless
steel screw for the substructure. Make sure to open
the gap between each panel with a sheet rock putty
knife to allow for expansion in hotter temperatures.
Ceiling and Wall Installation
EZ Liner™ PVC interlocking panels can be installed on walls and ceilings with the panel’s running
perpendicular or parallel to the main supports. For sloped applications, panels should run with the slope.
Before you start your installation, determine if your PVC application is in a wet environment or
a controlled (non-wet) environment. You can special order any of the install components. If
you have any questions concerning the install components required or need to order for
your project, please contact Polymershapes at (800) 421-0102 or send an email to
retail@polymershapes.com.
Wet Environment
If the PVC wall panels are being installed in a wet environment such as a car wash, the bottom
J-Trim piece needs to be installed rst.
Before installing the J-Trim, make sure to drill a ¼” (6mm) hole in the bottom of the J-Trim piece at
16” (400mm) on center for water drainage. This is especially important if the walls will be washed
with a power washer (see images A & B).
Picture A Picture B
Picture HPicture G
retail@polymershapes.com | (800) 421-0102
10