Product Manual A

Assembly Instructions
Classic Sectional Flagpole
Flying Your Classic Flag at Half-Mast
*To y your ag at half-mast on your Classic Sectional agpole, lower your
ag to half the height of the agpole with rope.
The bottom of the flag attaches to
the rope with a second nylon clip.
The top of the flag attaches to
rope with nylon clip.
Assembly Instructions
Classic Sectional Flagpole
Attaching Nylon Clip to Halyard:
l Bring halyard through loop (as show above) at the mid-length of the
halyard
l Attached the second nylon clip 36” (inches) below rst nylon clip.
l Tie the halyard together after pole assembly is put together and
placed upright. Latch halyard to cleat to secure.
Pole Assembly Order from Ground (Bottom) to Top:
l 13’ - Plain Section, Section with Cleat, Top Section
l 17’ - Plain Section, Section with Cleat, Plain Section, Top Section
l 21’ - Plain Section, Section with Cleat, Two (2) Plain Sections,
Top Section
Once Ground Sleeve has been installed and had proper time to cure,
you can assemble your agpole.
The Top Section with Truck Top installed and pre-strund with rope
will go at the very top of the agpole.
Section with cleat is to be insalled second from the bottom.