Installation Guide

PLEASE CHECK ALL PARTS against Packing Slip PRIOR to Installing
Molded
Parts
TUBE RECEIVERS
LEFT Side - SMALL Hole
RIGHT Side - LARGE Hole
CENTER
SUPPORT
END
BRACKET(S)
End Brackets NOT included in
all kits.
May be bought separately.
Shelf
&
Rod
Use End Brackets ONLY When:
(1) NOT mounting to side wall
(2) Connecting shelves to
make Longer Shelves
Shelf
(only)
NO ROD
3) Making Corners
4) When Making a Floating Shelf
HELPFUL INSTALLATION HINTS:
BEFORE INSERTING TUBES IN RECEIVERS: If Tube Ends have Tight Fit in Receivers, Coat Ends
with a little WD40, Liquid Soap, or Vegetable Oil using paper towel/rag.
CENTER SUPPORTS: If Putting a Lot of Weight on Shelf & Rod (over 200 lbs, or if not evenly
distributing weight, or if drywall may be weak), Attach 1 side of Center Support to Stud with
Screws & other side use Anchors/Screws to attach to drywall.
LONGER SHELVES: Two Shelves can be joined to make a longer shelf
WATCH Install Videos
at www.EzShelf.com
BEFORE Installation
Make End Bracket Assembly:
Snap a Right Tube Receiver
into Left Side of End Bracket
& Left Tube Receiver into
Right Side of same End Bracket &
Secure with included Nuts/Bolts.
CORNERS: Install 1 Shelf Unit between 2 walls, Snap
Tube Receiver intoEnd Bracket & Secure with
Bolts/Nuts. Picture on left shows a
Left Tube Receiver snapped into
Right side of End Bracket (perpendicular to first shelf)
to make your Corner and start the next shelf.
WRONG
TUBE NOT INSERTED
CORRECTLY
MUST BE FULLY
INSERTED
CORRECT
TUBE
INSERTED
FULLY INTO
TUBE RECEIVER