Installation Guide

EZ Shelf Instructions – Closet Shelf & Rod
**WATCH 2 Installation videos BEFORE Installation: www.ezshelf.com/videos
Included Plastic Parts
Tube Receivers – Left and Right
1 - Center
Support
1 - End Bracket – NOT INCLUDED- For mounting to Back Wall,
Corners &
Left
shown
Joining Shelves together for longer Shelf & Rod
Unit
End Bracket will NOT be needed if installing between two sidewalls (sides of a closet).
**For 1 Side Wall you will need to purchase 1 End Bracket (EZS-EB-SCRW for Shelf & Rod) or (EZS-
EB-SW for Shelf).
**If you have NO Side Walls and want to attach only to Back Wall you will need to purchase 2 End
Brackets.
Installing in a Tight Space
(40-44” wide for 40-73” tubes, and 28-32” wide for 28-48” tubes)
Insert ALL tubes into both left & right Tube Receivers BEFORE step 1.
Tubes will NOT fit into a tight space once the brackets are mounted to the wall.
Either have someone help hold the Shelf or mount Center Support Bracket First.
The tubes will NOT fit into a tight space once the brackets are mounted to the wall.
Mounting Tube Receiver to Sidewall
1. Measure & Mark Sidewall from floor up
Suggested Shelf Heights: Single Hanging: 60” - 80” from floor to top of shelf.
Double Hanging: 80” - 84” from floor to top shelf & 40” - 42” for bottom shelf.
2. Tape Tube Receiver Template to sidewall – Must be Level.
3. Mark Four Screw Holes with Pencil.
Note: Tube Receiver Installation: Large Holes MUST be on Top & Small, Protruding TAB MUST touch back wall (see
below).
Left Tube Receiver
TAB should be
touching against
back wall
Large Holes
on Top
Anchor/Screw Hole
Left Tube Receiver has SMALLER tube
diameter & holes than Right Tube Receiver