Manualshelf

Installation Guide

ManualsBrandsEZ Shelf ManualsAdjustable Mount Wire Shelving KitsEZS-SCRW72
12
601 North Congress Ave., Suite 606, Delray Beach, FL 33445
www.EzShelf.com Toll Free: 888-399-2880 Local: 561-303-3615
Suggested Shelf Heights:
Single Hanging: 60-80” from floor to top of the shelf.
Double Hanging: 82-84” from floor to top of top shelf, and 40-42” from floor to top of bottom shelf.
Included Plastic Parts
2 Tube Receivers
(note right and left)
Center Support
End Bracket(s)
(If ordered)
End Brackets are used
ONLY
Shelf & Rod
Parts
When
(1) NOT mounting
to a side wall or
(2)Connecting shelves to
make longer shelves
Shelf (only)
Parts
When
(1) NOT mounting
to a side wall or
(2)Connecting shelves to
make longer shelves
For EZ Installation, read all instructions and watch installation videos BEFORE beginning installation.
Installation videos: www.ezshelf.com/install.
1. Measure from floor & tape Tube Receiver Template on sidewall. MUST be LEVEL - Larger holes on top &
Anchor/Screw holes underneath with TAB at back touching back wall.
2. Mark Anchor/Screw holes by marking with pen - poking through “X’ on paper.
\
3. Remove Tube Receiver Template from side wall
TAB should be
touching
against back of
wall
Large Holes
on Top
Anchor/Screw Hole
Left Tube Bracket –
has smaller tube
diameter than Right
Sidewall Installation
EZS-SCRW72
EZS-SCRW48

Summary of content (2 pages)