Instructions / Assembly

Q. DOES THE IGNITER SPARK?
A. NO:
1. Check that the batteries are installed correctly and hold a positive charge.
2. Detach your gas supply (turning off gas supply will not release built up pressure so you must detach
gas supply to perform troubleshooting.)
3. Attempt running water through the unit with the gas supply detached. If your unit sparks the igniter
without the gas supply attached you may have a gas regulator with an outlet pressure too high.
Required gas pressure - 11"WC LPG - 8"WC NG
4. If the unit fails to spark the igniter with the gas supply detached, there may be an issue with the
microswitch used to control the electronics.
5. Remove the dial from the front of the unit and center the water flow and gas flow levers.
6. Removethecoverfromtheunit-screwsarelocatedatbottomrearcorners
7. With cover removed, locate red and blue wires running from computer board (bottom left corner) to
the micro switch (front and center). The wires are connected with using white connectors.
8. Detach the white connectors from each other, thus separating the computer board and micro switch.
9. Usinga“flat-blade
”screwdriver,completethecircuitbetweenthetwoprongslocatedinsidethe
white connector on the computer board side of the red and blue wires.
10. If a spark is produced when doing so, the unit micro switch has failed. If no spark is produced,
the unit computer board or battery compartment is faulty.
To test for a faulty battery compartment –
With unit cover removed, remove the red and black wires from the top of the battery compartment. Tape
two“D”cellbatteriesinaseries(configurationasfollows:+[battery#1]-+[battery#2]-).Withthe
batteries taped together securely, hold the red wire to the positive side of the batteries and the black wire
tothenegativesideofthebatteries.Againtouchthe“flat-blade”screwdrivertothetwopronglocated
inside the white connector on the computer board side of the red and blue wires. If a spark is produced, a
new battery compartment is required. If no spark is produced a new computer board is required.
EZ TANKLESS 202 OPERATION + INSTALLATION MANUAL
6.0 TROUBLESHOOTING
1. WATER HEATER FAILS TO IGNITE/HEAT WATER
PAGE 11.
Contact EZ Tankless Support - Mon-Fri 9am-5pm EST - [phone]