Instructions / Assembly

4
In the attic, locate the coat hanger wire. Adjust its
location, centering the opening for the tube between
the framing members. Check wire visibility in the
ceiling below as well as from the hole that will be cut
in the roof.
2
Using a stud finder or hammer, find a location
between the ceiling joists. Push a screwdriver or nail
through the desired position.
Cut and insert a section of coat hanger wire through
the hole. This will make it easier to identify the hole
location in the attic.
1
These instructions outline the step-by-step process to install an
Natural Light EZ Tubular Skylight. Before starting, review all
instructions and become familiar with the parts shown on the
previous page.
SPECIAL NOTES
• Always use safe procedures.
• Wear safety glasses when working with tools.
• Check all measurements before cutting or drilling.
• It is helpful to have a second person assist during installation.
Refer to Pre-Installation Checklist for tube location
tips in section i.
NOTE
Section-1
Determine The Desired Position
Of The EZ Tubular Skylight In The Ceiling
1
2
Carpenter Pencil
Claw Hammer
Coat Hanger Wire
Measuring Tape
Phillips Screwdriver
TOOLS & PARTS