Tools and Materials Needed: • Post hole digger or spade shovel • Level • Ruler or tape measure • 1 - 80lbs bag of quick setting concrete • 1/2 Gal.
Step-by-Step Instructions: 1.Select flagpole location. Check for underground sprinkler water lines and electrical lines before you dig. 2.Dig a 22'' hole with a tapered diameter, see diagram below. 3.Put 2'' of gravel under base of sleeve, (Allows for drainage) tamp stone. 4.Place aluminum sleeve (bead down) with bottom section of flagpole into place so cement won’t fill bottom of sleeve. 5.Mix bag of cement and pour into hole. 6.Mound up concrete around sleeve to allow for water runoff.