Installation Guide
Instructions for the HEAVY DUTY HITCH MOUNT Flagpole Kit
Flagpole Kit Includes:
l 2”x 72” Polished Aluminum Flagpole - 16 Gauge
l 2” Hitch Mount Flagpole Holder - Fits 2” Hitch Receiver
l 3” Aluminum Silver Ball
l 2” Top Cap installed on Flagpole
l 3’ x 5’ Nylon Sewn USA Flag (*Note not all vendors add ag)
l 1 - 2” Swivel Sleeve
l Clip Pack: 2 stainless steel clips, top swivel and washer
l 5/8” Trailer Hitch Pin
l Safety Coupler Pin
l Thumb Screw
STEP 1: Insert your Hitch Mount Flagpole holder into your vehicles hitch
receiver and secure it with your 5/8” pin.
STEP 2: Assemble your agpole. Slide your 2” swivel sleeve over the top
of your agpole then place the top swivel and washer on top of the Top
Cap and screw in your aluminum ball.
STEP 3: Add your ag to your agpole. Clip the top of your ag to the
Top Swivel & the bottom of your ag will clip to the rst loop on your 2”
Swivel Sleeve.
STEP 4: Push in the button located on the agpole and slide your 2”
Swivel Sleeve past the button. This will prevent your ag from rising to
the top of the pole.
STEP 5: Insert your agpole into your agpole holder.
STEP 6: Insert your Safety Coupler Pin to secure your agpole.
STEP 7: Tighten your Thumb Screw
STEP 8: Enjoy!
FOR PARTS AND SERVICE:
EZPOLE FLAGPOLES/ 1489 EAST 363RD STREET/ EASTLAKE, OHIO 44095
TOLL FREE: 888-454-9164/ LOCAL: 440-951-1011/ FAX: 440-951-2933/ www.ezpole.com