User's Manual

65
www.lairdtech.com
Laird Technologies
BTM510/511
Bluetooth
®
Multimedia Module
HF”CLIP,ERROR”
HFG has replied with ERROR to reception of “AT+CLIP<…>”.
HF”+CLIP,n,m,1234567”
A “calling line identication notication” (+CLIP:”1234567”,<type>) has been received
from the HFG. This message is sent by the HFG on incoming calls together with HF”RING”.
The HFG and telephone network must support this feature and the according ag (Bit 2) in
the HF supported features S register 581 must be set at boot time.
n = type of number (derived from the <type> in SLC message, not the original value):
0 – unknown
1 – international number
2 – national number
3 – network specic number
4 - dedicated access, short code
m = length of caller number (number of characters)
1234567 = caller number
HF”CCWA,OK”
HFG has replied with OK to reception of “AT+CCWA=1” or “AT+CCWA=0”.
HF”CCWA,ERROR”
HFG has replied with ERROR to reception of “AT+CCWA<…>”.
HF”+CNUM:’1234567’,ttt,s”
Response to a AT+CNUM request received from HFG:
1234567 – phone number in format specied by ttt
ttt – species the format of the phone number provided, and can be one of the following values:
- values 128-143: The phone number format bay be a national or international format,
and may contain prex and/or escape digits. No changes on the number presentation
are required.
- values 144-159: The phone number format is an international number, including
country code prex. If the plus sign (“+”) is not included as part of the number and
shall be added by the HFG as needed.
- values 160-175: National number. No prex nor escape digits included.
s – Indicates which service this phone number relates to. Shall be either 4 (voice) or 5 (fax).
HF”CNUM,OK”
HFG has replied with OK to reception of AT+CNUM (subscriber number information query).
HF”CNUM,ERROR”
HFG has replied with ERROR to reception of AT+CNUM (subscriber number information
query). A reason might be that this feature is not supported by the HFG.
HF”+COPS:m,ss,Operator”
Response to a AT+COPS? request received from HFG:
m – contains the current mode and contains no information with regard to the name
of the operator.
ss – size of the operator name in characters
Operator – the name of the network operator in alphanumeric format
HF”COPS,OK”
HFG has replied with OK to reception of “AT+COPS?”.
HF”COPS,ERROR”
HFG has replied with “ERROR” to reception of “AT+COPS”.
AT COMMAND SET
REFERENCE