User's Manual

BL600-Sx
Single Mode BLE Module
Note: Current production FW (v1.1.50.0) allows only 10bit mode.
4 POWER CONSUMPTION
4.1 Power Consumption
Parameter Min Typ Max Unit
Active mode (Advertising or Connection)
TX only run peak current @TXpwr= +4dBm
TX only run peak current @TXpwr= 0dBm
TX only run peak current @TXpwr= -4dBm
TX only run peak current @TXpwr= -8dBm
TX only run peak current @TXpwr= -12dBm
TX only run peak current @TXpwr= -16dBm
TX only run peak current @TXpwr= -20dBm
TX Whisper mode 1
TX only run peak current @TXpwr= -30dBm
TX Whisper mode 2
TX only run peak current @TXpwr= -55dBm
Active Mode
16
mA
10.5
mA
8
mA
7
mA
6.5
mA
6
mA
5.5
mA
5.5
mA
Need to
measure
RX only current 13 mA
Ultra Low Power Mode1 (note1)
Standby Doze
Standby Doze (UART on)
Ultra Low Power Mode2 Note2
Deep Sleep (no RAM retention)
Deep Sleep (8kB RAM retention)
Deep Sleep (16kB RAM retention)
3.5 uA
1.33mA to
be
measured
again
400 nA
600 nA
800 nA
Note 1: In Standby Doze, all functional blocks independently are in IDLE or RUN mode
depending on needed functionality. All peripherals that are enabled stay on and
may wake the chip again. Depending on active peripherals, current consumption will
be from ~2-3 µA up to > 1 mA. See individual peripherals current consumption in
Table xx on page.
Note 2: In Deep Sleep everything is disabled and the only wake-up sources are reset and
change on pins on which sense is enabled. The current consumption is ~1000nA to
1200nA (in current Nordic silicon). Current base FW ((v1.1.50.0) allows coming out of
11
www.lairdtech.com/wireless Laird