User's Manual
Table Of Contents
- Part # BL600-SA, BL600-SC, BL600-ST
- 3.1 SW Block diagram
- 3.3 Electrical Specifications
- 4.2 Measured waveforms
- 4.3 Peripheral block current consumption
- 5.1 Power management (includes brown-out and power on reset)
- 5.2 Clocks
- 5.3 Memory for smartBASIC application code
- 5.4 RF
- 5.5 UART Interface
- 5.6 SPI Bus
- 5.7 I2C Interface
- 5.8 General Purpose I/O and ADC
- 6.1 Circuit Components Required on Host PCB
- 6.2 BL600-Sx General PCB Layout on Host PCB
- 6.3 BL600-SA Layout on Host PCB
- 6.4 BL600-ST Layout on Host PCB
- 8.1 Introduction
- 8.2 Shipping
- 8.3 Reflow Parameters
- 9.2 OEM Responsibilities
- 10 Japan (MIC) Regulatory
- 11 CE Regulatory
- 12 EU DECLARATIONS OF CONFORMITY
- 14 ORDERING INFORMATION
BL600-Sx
Single Mode BLE Module
Specification
Value
Unit
Item Part Number Mfg. Type Gain (dBi) Model
Upper Target Reflow Temperature 250 °C
Absolute Peak Temperature
260
°C
9
FCC AND IC REGULATORY STATMENTS
Model US/FCC CANADA/IC
BL600-SA PI4BL600 1931B-BL600
BL600-SC PI4BL600 1931B-BL600
BL600-ST PI4BL600T 1931B-BL600T
Important: The BL600-ST holds a limited
modular approval for the U.S and Canada markets. To ensure regulatory
compliance when integrating the BL600-ST into a host device, it is necessary to
follow the design implementation requirements in this manual so the BL600-ST
modular certification can carry over to the host device. If these requirements
cannot be met, the OEM will need to either seek a new FCC/ IC approval for their
device or seek a Class 2 Permissive Change through Laird Technologies which adds
the new antenna layout to the BL600-St approval. Contact Laird Technologies for
further guidance.
The BL600-SA and BL600-SC hold full modular approvals. The OEM must follow the regulatory
guidelines and warnings listed below to inherit the modular approval.
PART # FORM FACTOR TX OUTPUT ANTENNA
BL600-SA-XX
Surface Mount
4dBm
Ceramic
BL600-SC-XX
Surface Mount
4dBm
IPEX MHF4
BL600-ST-XX
Surface Mount
4dBm
Trace Pad
*Last two slots "XX" in Part # are used for production firmware release changes. Can be values
01-99, aa-zz
The BL600 family has been designed to operate with the antennas listed below with a maximum
gain of 2.21 dBi. The required antenna impedance is 50 ohms.
1 AT5020-E3R0HBANT/LF ACX Ceramic 0 BL600-SA
2 EDA-8709-2G4C1-B27-CY MAG. Layers Dipole 2.0 BL600-SC
3 PCA-4606-2G4C1-A33-CY MAG. Layers Dipole 2.21 BL600-SC
4 EDA-8709-2G4R2-A40-CY MAG. Layers Dipole 2.0 BL600-ST
25
www.lairdtech.com/wireless Laird