User's Manual
Table Of Contents
- Part # BL600-SA, BL600-SC, BL600-ST
- 3.1 SW Block diagram
- 3.3 Electrical Specifications
- 4.2 Measured waveforms
- 4.3 Peripheral block current consumption
- 5.1 Power management (includes brown-out and power on reset)
- 5.2 Clocks
- 5.3 Memory for smartBASIC application code
- 5.4 RF
- 5.5 UART Interface
- 5.6 SPI Bus
- 5.7 I2C Interface
- 5.8 General Purpose I/O and ADC
- 6.1 Circuit Components Required on Host PCB
- 6.2 BL600-Sx General PCB Layout on Host PCB
- 6.3 BL600-SA Layout on Host PCB
- 6.4 BL600-ST Layout on Host PCB
- 8.1 Introduction
- 8.2 Shipping
- 8.3 Reflow Parameters
- 9.2 OEM Responsibilities
- 10 Japan (MIC) Regulatory
- 11 CE Regulatory
- 12 EU DECLARATIONS OF CONFORMITY
- 14 ORDERING INFORMATION
BL600-Sx
Single Mode BLE Module
NOTE IMPORTANTE:
Dans le cas où ces conditions ne peuvent être satisfaites (par exemple pour certaines
configurations d'ordinateur portable ou de certaines co-localisation avec un autre émetteur),
l'autorisation du Canada n'est plus considéré comme valide et l'ID IC ne peut pas être utilisé sur le
produit final. Dans ces circonstances, l'intégrateur OEM sera chargé de réévaluer le produit final
(y compris l'émetteur) et l'obtention d'une autorisation distincte au Canada.
29
www.lairdtech.com/wireless Laird