User's Manual

2
Base Station
Loudspeaker
Power Button
Ethernet Port/
Network Indicator
Power Port
Reset Button
LED Indicator
Micro SD Card Slot
SYNC Button
Name Description
LED Indicator • Solid Green: The base station works properly.
• Solid Blue: The base station is not connected to the Internet.
• Flashing Blue: The base station is pairing with the camera.
• Solid White: Restore factory settings successfully.
• Flashing Red: An alarm occurs.
• Solid Red: SD card error.
SYNC Button • Short press to turn off the siren when an alarm occurs.
• Holdfor2secondstostartpairingwiththecamera(Pairingcanlastup
to 2 minutes).
Power Button Press to connect or cut off power.
Network Indicator Solid Green: The Ethernet cable is connected.
Reset Button Hold for 5 seconds to restart and reset all parameters to default.
Setup
Step 1: Charge the Camera (Optional)
Connect the camera to power outlet with the power adapter (5V 2A).
If the camera is powered off, short press the SYNC button to power on.
Power Outlet
Power Adapter
• Remove the camera from the wall before charging.
• Please do not charge the camera when the temperature exceeds 45 degrees or below 0
degrees.
• It is not allowed to charge the camera with power adapter outdoors.
• When charging, the camera will automatically turn on.
Step 2: Power on the Base Station
Connect the base station to power outlet with the power adapter (12V 1A).
Power Outlet
Power Adapter