User's Manual

2
Setup
Follow the steps to set your detector:
1. Get the EZVIZ app, and log in to your EZVIZ app account.
2. Power on your water sensor.
3. Add your water sensor to your EZVIZ account.
1� Get the EZVIZ App
1. Connect your mobile phone to Wi-Fi (suggested).
2. Download and install the EZVIZ app by searching for “EZVIZ” in the App Store
or Google Play
TM
.
3. Launch the app and register an EZVIZ user account.
EZVIZ App
If you have already used the app, please make sure that it is the latest version. To find
out if an update is available, go to the app store and search for "EZVIZ".
2� Power on Water Sensor
Step 1 Remove Rear Cover
Remove the rear cover of the water sensor by rotating it unticlockwise with sheet
tools like 1 yuan coin as shown in the gure below. It is recommended to press
the coin into the groove and then rotate it.
Step 2 Remove Insulation Strip
Remove the battery insulation strip as shown in the gure below.
Insulation Strip
• If you need to replace the battery, please purchase one CR2032 210mAh.
• When replacing batteries, please insert with the positive side facing up
.
• Keep your hands dry and clean when touching the circuit board.