User's Manual

3
3� Add Water Sensor
The water sensor should be used along with EZVIZ Zigbee Smart Gateway (afterinafter
referred to as "gateway"). Please add gateway to the EZVIZ Cloud by referring to the gateway
user manual, and then add the water sensor to the gateway.
Method One: Add by Scanning QR Code
1. Log in to your account through EZVIZ app, tap the device adding icon and then
the QR code scanning interface will be displayed.
2. Remove the rear cover of the water sensor by rotating it unticlockwise with
sheet tools like 1 yuan coin as shown in the gure below. It is recommended to
press the coin into the groove and then rotate it.
3. Scan the QR code on inner side of the upper cover of the water sensor.
4. Add the water sensor to the gateway by following the wizard on the app.
5. Rotate tightly the rear cover of the water sensor clockwise till the aligning
mark is aligned with the mark on the front cover.
When rotate the rear cover of the water sensor, press the coin into the groove and then
rotate it.
Method Two: Add by the Gateway
When adding water sensor by the gateway, place the water sensor as close to the gateway as
possible.
1. Make the gateway enter device adding mode as instructed by the user manual
of the gateway.
2. Remove the rear cover of the water sensor by rotating it unticlockwise with
sheet tools like 1 yuan coin as shown in the gure below. It is recommended to
press the coin into the groove and then rotate it.