User's Manual

4
3. Press and hold the water sensor Button for 5 seconds, and then the water
sensor enters device adding mode.
Button
4. When the water sensor indicator ashes blue quickly and then off, the water
sensor has been added to the gateway successfully.
5. After the water sensor is added successfully, Rotate the sensor rear cover
clockwise to tighten the rear cover till the aligning mark on rear cover is aligned
with the mark on the front cover.
Installation
The water sensor can be put on the any plane surfaces of restroom, veranda, kitchen,
warehouse and etc..
• Please install the water sensor on areas prone to water leakage.
• Do not install the water sensor on places where water has already flooded.
• Do not install the water sensor on places with people comes and goes to avoid losing.
• Do not install the water sensor in an environment with corrosivity or intense magnetic fields.
• It is recommended that the distance between the water sensor and gateway be less than 20m. If
there are walls between them, the number of walls should be no more than 2.
• If you have a house with large area, please purchase two or more EZVIZ devices for a better use
effect.