Owners manual

Bumper Installation

Installation Instructions

Dodge Winch Bumper

Product Number: A2950-A2952

Application: 2010+ Dodge Ram HD

 Optional: If installing winch and roller fairlead into bumper, do it at this

time. Follow the winch manufacturer’s instructions for installation. If you are

installing a winch with a pulling capacity of 12,000 lbs. or greater, the front

face mounting holes must be used.

If not installing a winch, a license plate may be installed onto the front face of

the bumper using the provided ¼” hardware.

1. Install intermediate mount onto the frame rail using the 9/16” x 4” bolts and

nuts through the FRAME UNDER RUN GUARD holes, and then replace the

bolt strip in the original orientation. Insert all hardware from the inside out,

with the nuts accessible from the outside of the frame rail. DO NOT FULLY

TIGHTEN, repeat for other side.

Figure 9 - Intermediate Bracket Installation