Owners manual

Installation Instructions

Toyota Tundra Rear Bumper

Product Number: W2850

Application: ’14 Toyota Tundra

Tools Required

 Socket Wrench with Extension

 3/4”, 12mm, & 19mm Sockets

(ratcheting wrenches may also be convenient)

 3/4”, 12mm , & 11/32” Box End Wrenches

 3/32” Allen Wrench

 Flat and Phillips Head Screw Drivers

 Floor Jack and wood block.

II. Removal of Stock Bumper

A. Disconnect the harness on the back side of the license

plate lights from the main connector on the truck frame.

Secure the harness out of harms way to the back of the

bumper.

B. Remove your license plate from the OEM Bumper.

C. Remove the plastic corner pieces from the top of the

OEM bumper by pulling up from the outside edge. If the

plastic is being stubborn during removal the plastic clips

can be popped loose from the bottom side of the

bumper.(Figure 1)

Figure 1