Installation Instructions

15
Cleaningmetalgreaselters
The lters must be cleaned every 2 months of opera-
tion, or more frequently for particularly heavy usage,
and can be washed in a dishwasher.The metal grease
lters should be cleaned frequently in hot detergent
solution or washed in the dishwasher. Stainless steel
cleaner should be used on stainless rangehoods.
Abrasives and scouring agents can scratch stain-
less steel nishes and should not be used to clean
nished surface. Remove all water or any other liquid
from washing before re-installing lters.
• Remove the lters one at a time, supporting
them with one hand and turning the safety
knobs (pull and turn).
• Wash the lters, taking care not to bend them.
Allow them to dry before retting.
• Replace them and x them using the safety
knobs provided (pull and turn).
• No water can be present in lters before install-
ing back in hood.
Replacing Activated Charcoal Filter
The lter is not washable and cannot be regenerated,
and must be replaced approximately every 4 months of
operation, or more frequently for particularly heavy usage.
• Remove the Filters one at a time, pushing them
towards the back of the unit and at the same time
pulling downward.
• Remove the saturated charcoal lter by releasing the
xing hooks.
• Fit the new lter and fasten it in its correct position.
• Replace, taking care to ensure that the handle faces
forwards.
• CAUTION: When used in recirculation mode, to Re-
duce the Risk of Fire and Shock use only conversion
kit Model FILTER2.
Lighting unit
• Remove the snap-on lamp cover
by levering it from under the metal
ring, supporting it with one hand.
• Replace the lamp with a new one
of the same type, making sure that
you insert the two pins properly into
the housings on the lamp holder.
• Replace the snap-on lamp cover.
Gu10 self-ballasted led
lamps – listed in ac-
cordance with
ul 1993/nmx-
j-578/1-ance/
csa c22.2 No.
1993