Installation instructions

Version 07/11 - Page 8

For ductless installations, install the CHARCOAL FILTER (F in

FIGURE 10) 

and locking into place. See FIGURE 14

WARNING



Two people must hold the canopy in place while the third person installs the screws that attach the canopy to the chimney.

The manufacturer assumes no responsibility for injury or damage caused by improper installations.

4. From below, attach the CANOPY SECTION (A in FIGURE

12) to the assembled chimney support using the four bolts

provided (F in FIGURE 12).

FIGURE 12

FIGURE 14

6. 

turning the knob to the left so that the locking lever does not

(as in FIGURE 15). Insert the opposite





FIGURE 15

7. Turn the power supply on. Turn on blower and lights. If the

rangehood does not operate, check that the circuit breaker

is not tripped or the house fuse blown. If the unit still does

not operate, disconnect the power supply and check that the

wiring connections have been made properly.

5.

A in FIGURE 13

indicated in B in FIGURE 13. Insert the connected CONTROL

(A in FIGURE 13) into the black plastic CONNECTOR

(C in FIGURE 13) by connecting the two black plastic

pieces using the four screws provided. Using the two longer



the METAL FLANGE (D in FIGURE 13).

FIGURE 14

MAKE THE INTERNAL ELECTRICAL CONNECTIONS