Specification Sheet

STRATUS ISOLA WHITE
ISLAND RANGE HOOD
SPEED 1 2 3 BOOST
CFM 150 300 450 560
Sones 3.9 5 6.0 7.0
SPECIFICATIONS DIMENSIONS
ACCESSORIES
Rev :4/21
2 Cabot Road Hudson, MA 01749 • TEL: [phone] • E-Mail: [e-mail] www.faberonline.com
Imagined in Italy
WARNING! Product specications are subject to
change without notication. Consult the installation
instructions before you begin installing this range
hood. * Check local make up air codes for
guidelines.
PERFORMANCE
min / max ceiling height 5' 11" - 9' (up to 72" above the stove)
convertible to ductless /
recirculating
yes – kit sold separately
hood width | depth (36") 35 7/16" w | 18 1/2" d
hood width | depth (48") 47 1/4" w | 27 9/16" d
controls 4 Speed LED Digital Touch Control
lighting 2 LED Light Bars
ducting 6" round -4 Way side Vent / 10" top only
grease filters dishwasher safe mesh
Perimetric Filter/ SilentKit yes
24 hour anti-pollution mode yes
10 minute intensive speed yes
30 minute auto shut off yes
filter wash alarm yes
ADA compliant yes (with included remote control)
AC power 400 watts / 3.2 amps (with IB600)
Overall
Ceiling Cut Out
# FILTER1–
Charcoal Filter Kit
High quality charcoal filter
for use when recirculating
the air back into the kitchen.
Filters out odor and should be
replaced every 6 months.
# FILTER1LL2 –
Long Lasting Charcoal
Filter Kit
New washable charcoal filter
can be recharged and washed
up to 8 times. For use when
recirculating the air back into
the kitchen filters. out odor
and can last up to 4 years.
# FLANGE10–
10" Plate for Remote Blower
A 10" plate for connecting the
remote blower to 10" round
ducting. This is required for
AXP250 & non-Faber remote
blowers
# MUDAMPER6 / MUDAMPER8
/ MUDAMPER10 –
Universal Make-Up Air Damper
Satisfies make-up air requirements,
this kit uses an air switch to activate
the make-up air damper to open
and bring fresh air into the home
when the hood fan is on. It then
closes tightly when the hood is off.
The CFM level is not reduced with
this accessory.
Bottom/Side
# FLANGE3 – 3 1/4” x
10” Rectangular Flange
Transition
For ceiling or downdraft hoods with
an external blower that requires a
10" round duct, this transition turns
the duct into a 3 1/4" x 10" rectangu-
lar duct. Transition back to 10" round
once inside the basement, ceiling,
attic, wall etc.