Instructions / Assembly

23
STANDARD TRIM PARTS
See page 15 for
Illustration of Trim Conditions
CHIMNEY OR SKYLIGHT
See pages 20-22
EAVE TRIM
This piece is used at the eave or gutter edge of the building, and must be installed before any panels.
ENDWALL
This piece is used when the upper end of panel butts into a vertical wall.
FASTENERS
 #14 X 1” MILL POINT SCREW
This fastener is used to attach trim to the panels, and also to attach panels directly to the roof deck.
 #14 x 1½” MILL POINT SCREW
This fastener is used to attach trim through the high rib of the panel, and also to attach panels to the roof
deck.
GABLE TRIM
This piece is installed on the house between the ridge and the eave, holding down the first panel edge and the last panel
edge. Gable-trim seals out the weather and gives a neat finished appearance.
GAMBREL CONDITION - AT-2
This trim is used to transition from low-slope panels on the top section to steep-slope panels on the lower section.
HIP CAP
This piece covers projecting angles formed at the intersection of the two sloping roof planes.
MONOSLOPE PEAK CAP - CP-1
This piece is used at the top of a single sloped roof.
RIDGE CAP
This piece is used at the peak of a typical two-slope roof. The ridge can be ventilated, by using Profile Vent in place of
sealant and outside closures.
SIDEWALL
This piece is used when the roofing panel is installed parallel to a vertical wall.
SLOPE TRANSITION - AT-1
This piece is used where two roofs of different pitch meet, the top section being steeper than the lower section.
W-VALLEY
Used to flash the valley formed by intersecting roof planes.
This list of flashing can be used in conjunction with the Home Legend drawing on page 15 to help you understand placement and
proper installation.
Key Terms