Installation Instructions / Warranty 90573601-00 7/2005 Starck Tub Filler 10402XX1
Starck Tub Filler 10402XX1 Technical Specification Maximum incoming water pressure Recommended water pressure Recommended max. incoming hot water temp. Flow rate of tub filler @ 45 psi Flow rate of handshower Backflow prevention furnished by check valve in closing diverter 145 psi 14.5 - 72 psi 120oF - 140oF* 5.75 gpm 2.
Installation • Flush the supply lines for at least 5 minutes before installing the tub filler. Damage to the cartridge caused by debris is not covered under the Hansgrohe warranty. • Wrap the threads on the S-connectors with Teflon® thread tape. Screw the Sconnectors into the female fittings and align them so that they are level and are 5 7/8" apart on center. The end of the S-connector should extend 1 3/8” outside the surface of the finished wall.
User Instructions • Pivot the lever upward to turn the water on, down to turn it off. Pivot the handle left to obtain warmer water, to the right to obtain cooler water. • When the unit is turned on, the water will come from the tub filler. Pull the diverter knob to obtain water from the handshower When the water is turned off, the diverter will automatically reset to the tub filler position. • The handshower uses the Rubit!™ self-cleaning system.
• Remove the handle screw. Pull the green high temperature limit stop straight off the cartridge. • Reinstall the high temperature limit stop so that the positioning pin on the cartridge is in the hole for the desired high temperature. The temperatures shown on the diagram assume an incoming cold water temperature of 50oF and an incoming hot water temperature of 140oF. • Test the unit. Reposition the high temperature limit stop again if required. • Reinstall the nut cover.
Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the Hansgrohe warranty. Cleaning Materials for Faucets and Showers • • • • To remove lime scale, use only products made specifically for that purpose.
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: A. Conditions, malfunctions or damage not resulting from defects in material or workmanship. B. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner contrary to the product instructions. C.
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 Tel. 770 360-9880 • Fax 770 360 9887 www.hansgrohe-USA.
