Instruction Manual

2-3/8"
(60mm)
or
2-3/4"
(70mm)
1-1/2
(38mm)
hole
2-3/4" (70mm)
1. Install latch and Strike.
Fig.3
Fig.1
d.Leavetheboltintheextendedposition.
e.Installstrikewithtwo1-1/2”(38mm)woodscrews(see
gure5).
2. Remove cover and battery case.
2
Area
Crank
Use the checklist below to assure completion of important steps.
□PREPAREDOORASREQUIRED............
□INSTALLLATCHANDSTRIKE................
□INSTALLEXTERIORASSEMBLY............
□INSTALLMOUNTINGPLATE...................
□ATTACHCONNECTOR............................
□INSTALLINTERIORASSEMBLY.............
□RUN“BOLTDIRECTION”ROUTINE.......
□PROGRAMCODE(S)................................
□VERIFYOPERATION................................
Ontemplate(included)
Section 1
Section 3
Section 4
Section 5
Section 6
Section 8
Section 9 a, b, c
Section 9 d
a. Determine your backset, see
gure1.
b. Ifa2-3/4”(70mm)backsetis
required, extend bolt and adjust
latch as shown.(Seegure2).
Fig.2
Fig.5
Fig.4
c. Install latch, securing with small
woodscrews(seegure3).Note: For
a 1-1/2” (38mm) diameter hole, test if
latch extends and retracts smoothly.
Area indicated may require addition
clearance for crank of latch to function
properly (see gure 4).
a.Removecoverfromassemblybysliding
coverupandoff,seegure.6
b.Removethebatterycasefrominterior
assemblybyliftingthecaseupandoutand
setaside,seegure7.
Fig.7Fig.6
Importantbeforeproceeding: 1. Verifythatposition#2ofthe“Settings
Switch”isintheOFFposition.(Refertosection11.)2. Work with the
dooropen(awayfromjamb)toavoidaccidentallockout.3. Make sure
theboltoflatchisintheextended(locked)position.