Instruction Manual

UP
KEEP
PARALLEL
3. Install Exterior Assembly.
Bolt
3
Wire
Harness
Adapter
For2-1/8”
diameteronly.
Fig.9
Fig.8Fig.7
a. Place adapter on door as shown,
(note,adapterisnotrequiredif
mountingona1-1/2”(38mm)
diameterhole.
Crank
Torque
Blade
c. Place assembly on door, threading
thewireharness(throughadapter-if
used)andunderthelatch.
b. Insert cylinder into exterior
assembly.Withkeyincylinder,
rotate the torque blade to align
withcrankinlatch.
a. Carefullyangletheconnectorofthewireharness-throughthecenter
holeofthemountingplate,utilizingthenotchholetoallowconnectortopass
through(seegure7).
e.Checktheverticalalignmentformounting
plate and exteriorassembly.(Seegure9.)
h.Repeatasrequired.
f.Test.Usingthekey,retractandextendthe
boltafewtimestotestforsmoothaction.
c. Slide wires through the notch until mounting
platesitsushagainstdoor.
4.InstallInteriorMountingplate.
Mounting
Plate
b. Important, once the connector has passed through the center hole, tuck
thewireharnessoutofthewaybypressingitintothenotchholeasshown
ingure8.
Notch
Hole
d. Making sure that exterior assembly and
cylinder arepressedushagainstexterior
door,insertmountingboltsandtighten.
g.Ifactionfeelsrough,loosenscrewsand
re-align the mounting plate and the exterior
assembly.Note:Alsoseestep1-cforpossible
crankinterference.