Instruction Manual

Wire Harness
Small
Screws
Torque Blade
Important Note: To prevent damage, always handle the wire harness
with care.
4
Routewiresdown-avoidingany
excess bulge at curve, which could
interferewithbatterypackinstallation.
5.AttachtheConnectortotheInteriorAssembly.
Connector Port
Interior
Assembly
Connector
Connector
Wire Harness
a. Makingsurewiresareclearofpinchingandwireharnessisroutedas
shown, place the interior assembly on door, aligning torque blade inside the
turnpieceshaft.
6. Install Interior Assembly.
Turnpiece
Shaft
b.Onceushondoor,
insert and tighten small screws
to secure assembly onto the
mountingplate.Note: To aid insertion of screws,
approach the screw holes with the screw loaded onto the screwdriver.
a.Aligntheconnector(smoothsideup)withtheconnectorportoftheinte-
riorassembly.
c.Oncealigned,pushtheconnectorinrmlytoconnect.
b.Foreasierorientation,viewthealignmentofconnectionfromthetopof
theinteriorassembly.
Topof
Interior
Assembly