Instruction manual

english
22
4
5
Troubleshooting
Safety
You can solve the following problems yourself:
4.1 4.1 The oven is not heating up. Check it is
plugged in and switched on and that the fuse
has not blown. Select a higher temperature
setting.
4.2 The interior light is not working. Change the
bulb or replace the fuse.
4.3 Smoke is coming out during cooking. Turn
the temperature down and/or clean the oven.
4.4 The pyrolysis cleaning process is not
being carried out. Ensure the door
is correctly closed. Locking system or
temperature sensor failure. Call the Technical
Service.
4.5 A beep is sounding. The selected
temperature setting has been reached. The
• The oven must be installed by an authorised
installer in accordance with the manufacturer’s
instructions and diagrams.
• The electrical installation must be dimensioned
for the maximum power indicated on the
reference plate and the electrical socket must
have a regulatory earth connection.
• The mains circuit supplying the oven must have
a single-pole cut-off switch with at least 3 mm
between contacts.
• If the power cord is damaged, it must be
replaced by the after-sales technical service or
by similarly qualifi ed staff, to avoid hazard.
• Ensure the appliance is unplugged from the
mains before replacing the oven lamp, to avoid
electric shock.
• Do not use abrasive cleaning products or metal
scouring pads to clean the oven door, as they
could scratch the surface and cause the glass
to shatter.
remaining accessories so that they provide
leverage to lift up the glass (3.7.3). Remove
the glass (3.7.4), clean it and dry it with a
cloth (3.7.5). If necessary, remove the whole
glass panel unit inside the door. This unit
consists of either one or two glass panels,
depending on the model, with a black stop
in each corner. To remove them, place your
hand under the door and pull upwards
(3.7.6). When you have taken out the unit,
remove the stops to clean the glass panels
(3.7.7).
When the glass panels are clean (3.7.8) fi t
them onto the rubber stops again, with the
stud facing upwards (3.7.9) and replace the
glass panels so that the letters “L” (left) and
“R” (right) are beside the hinges (3.7.10).
Lastly, place the remaining glass panel so
that the word PYROLYTIC can be read
(3.7.11). Remove the stops (3.7.12) and
close the door.
Warnings:
• Make sure the oven is switched off.
• Allow the glass to cool down before
removing it.
• Never use steam cleaning machines.
3.8 Cleaning the outside of the oven. Use
neutral cleaning products. Dry the oven well
with a soft cloth.
cooking cycle is complete.
4.6 The oven makes a noise after cooking.
This is normal, as the fan keeps running until
the temperature inside and outside the oven
is reduced.
4.7 Failure warnings.
Temperature sensor failure.
Door blocked (4.7.1).
Pyrolysis cannot be carried out.
Door block failure.
Software Failure
Power cut during cooking.
The oven automatically switches
off as it has been functioning for
several hours (4.7.2).
Do not try to repair the oven yourself. Call
the technical assistance service.