MANUAL FAGOR WC-46DZ

12
IMPORTANT INFORMATION ABOUT
TEMPERATURE
Your appliance has been designed to guarantee
optimum conditions for storing and/or serving your
wines.
Fine wines require long and gentle developmental
periods and need specific conditions in which to
reach their full potential.
All wines mature at the same temperature, which is
a constant temperature set between 52ºF to 57ºF or
11ºC to 14ºC. Only the temperature of “dégustation”
(wine appreciation) varies according to the type of
wine (see “Wine Serving Temperature Chart” on
page 11). As it is for natural cellars used by wine
producers for long periods of storage, it is not the
exact temperature that is important, but the
consistency of the temperature. In other words, as
long as the temperature of your wine cellar is
constant (between 52ºF to 57ºF or 11ºC to 14ºC)
your wines will be stored in perfect conditions.
Not all wines will improve over the years. Some
should be consumed at an early age (2 to 3 years)
while others have tremendous ageing capability
(50+ years). All wines have a peak in maturity. Do
check with your wine merchant to get the
appropriate information for your wine.
CARE AND MAINTENANCE
WARNING: Failure to unplug the appliance during
service and cleaning could result in electric shock or
other personal injury.
REMOVING SHELVES
 To remove any of the shelves from the rail
compartment, move the shelf to the position
where the notch of wooden shelf is exactly
under the plastic post and then lift it up and out.
 In order to replace the shelf, repeat steps
described above in reverse. Make sure to
engage the shelves with the small pegs of the
extended rails when the model is equipped with
roller system.
ACTIVE CHARCOAL AIR FILTER
Replace the active charcoal air filter with a new one
once a year. You can order a new filter by calling
Fagor Technical Service Center at: 1-877-743-2467,
or by going to the online shop section of our website:
www.fagoramerica.com.
 Grip the filter and turn it 90°clockwise or
counterclockwise to remove.
 Insert the new filter in the vertical position.
Turn the filter 90° clockwise or
counterclockwise until it clicks into position.