MANUAL FAGOR WC-46DZ

14
PROBLEMS WITH YOUR APPLIANCE
You can solve many common problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling customer service.
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE CAUSE REMEDY
Appliance does not
operate.
1. Appliance is not connected to a power supply.
2. The appliance is turned off.
3. The circuit breaker tripped or blew fuse.
1. Connect the appliance.
2. Switch on the appliance.
3. Switch on circuit breaker or
replace fuse.
Appliance is not cold
enough.
1. The temperature is not set correctly.
2. The ambient temperature could require an
adjusted temperature setting.
3. The door was opened too often or held open for
too long.
4. The door was not closed completely.
5. Door is not sealed tight enough.
6. The condenser is too dirty.
7. The ventilation opening is blocked or too dusty.
1. Check the set temperature.
2. Set a higher temperature.
3. Do not open the door more than
necessary.
4. Close door properly.
5. Check that the door seal is
clean and replace if necessary.
6. Clean the condenser when
necessary.
7. Clear the obstructions and clean
the dust.
Appliance turns itself
on and off frequently.
1. The room temperature is higher than average.
2. A large amount of bottles has been added to
the unit.
3. The door is opened too often.
4. The door is not closed completely.
5. The door gasket does not seal properly.
1. Put the appliance in a cooler
place.
2. Leave the appliance untouched
for a while until the set
temperature has been reached.
3. Do not open the door more often
than necessary.
4. Close door properly.
5. Check that the door seal is
clean and replace if necessary.
The light does not
work.
1. Appliance is not connected to a power supply.
2. The circuit breaker tripped or blew a fuse.
3. The light was switched off on the control panel.
1. Connect the appliance.
2. Switch on circuit breaker or
replace fuse.
3. Switch on the light.
Vibrations.
1. The appliance is not properly leveled. 1. Level the appliance with the
adjustable feet.
The appliance seems
to make too much
noise.
The rattling noise may come from the flow of the refrigerant, which is normal. As each cycle
ends, you may hear gurgling sounds caused by the flow of refrigerant in your appliance.
If temperature fluctuations occur, the contraction and expansion of the inner walls may
cause popping and cracking noises.
1. The appliance is not properly level. 1. Level the appliance with the
adjustable feet.
The door will not
close properly.
1. The appliance is not properly leveled.
2. The door was reversed and not properly
installed.
3. The gasket is dirty.
4. The shelves are out of position.
1. Level the appliance with the
adjustable feet.
2. Check the door hinge and
reassemble correctly (See
Reversing the Door Hinge
section on page 7).
3. Clean the door gasket.
4. Check the shelves and
reposition correctly.
Display shows “E1”.
“E2” or “E7”.
1. “E1” or “E2” indicates that the air temperature
sensor is failed.
2. E7” indicates the door switch failure.
Call for service.