MANUAL FAGOR WC-46DZ

9
USE AND CONTROL
The Controls of Your Unit
POWER
To turn the appliance on or off, press and hold the
button for 1 second.
NOTE: Pressing the
button once can switch off
the audible alarm when the alarm is on.
UP
Used to increase (warm) the set temperature by 1°F
or 1ºC.
DOWN
Used to decrease (cool) the set temperature by 1°F
or 1ºC.
LIGHT
Used to turn the inner light on and off.
Display
Displays the temperature and service indicators.
is for the UPPER temperature zone and is for
the LOWER temperature zone.
ºF/ºC Selector
Program the temperature display in either
Fahrenheit or Celsius. To change the temperature
from Fahrenheit to Celsius or from Celsius to
Fahrenheit, press and hold the LIGHT button for 5
seconds.
Setting the Temperature Control
 The unit has two separate temperature zones.
The temperature of both zones can be set
between 41ºF and 68ºF (5ºC and 20ºC).
 When the unit is plugged in for the first time, the
unit will power up automatically to the preset
defaults. The default temperature for the
UPPER temperature zone is 50ºF (10ºC) and
for the LOWER temperature zone is 60ºF
(16ºC).
 You can press the left side UP and DOWN
buttons to control the internal temperature of
the UPPER temperature zone and press the
right side UP and DOWN buttons to control the
internal temperature of the LOWER
temperature zone. When you press the UP or
DOWN buttons, the displayed temperature will
change accordingly.
NOTE: The temperature set for the LOWER
temperature zone must always be just as high,
or higher, than that of the UPPER temperature
zone. For optimal performance, the set
temperature of the two zones should differ by at
least 7°F or 4°C.
 The temperature that you desire to set will
increase 1ºF or 1ºC if you press the UP button
once. The temperature will decrease 1ºF or 1ºC
if you press the DOWN button once. The
display will flash while you make your selection.
TEMPERATURE DISPLAY
During normal operation, the temperature display on
the control panel always shows the SET
temperature. The temperature display will flash if:
- A different temperature is being set.
- The temperature in the zone deviates by more
than 9°F or 5°C from the set temperature.
The temperature display flashing ensures that the
temperature cannot rise or fall un-noticed.
TEMPERATURE MEMORY FUNCTION
In the event of a power interruption (power surge,
breaker switch failure, etc.), the unit will remember
the last temperature settings and, when the power is
recovered, the cabinet temperature will go back to
the same set temperature as before the power
interruption.
TEMPERATURE ALARM
An alarm will sound if the temperature in one of the
zones rises or falls outside the temperature range.
The relevant temperature display will flash at the
same time.
The temperature the appliance is set at determines
the temperature the appliance recognizes as being
too warm or too cool.
The alarm will sound and the temperature display
will flash:
- If the temperature inside the appliance is very
different from the temperature set.
- When there has been a lengthy interruption to
the power supply.
- When too many items have been put into the
unit at one time. This can be as a result of
holding the door open too long or from
overloading the unit past its recommended
capacity.
- When the door is not been closed tightly.
THE ALARM CAN BE DEACTIVATED BY
PRESSING THE POWER BUTTON