Instruction Manual

ManualsBrandsFairbanks ManualsHardwareX SERIES PR 5410 Process Indicator

131

132

133

134

135

136

137

138

139

140

Section 9: Configuration Print-Out

10/08 139 51207 Revision 1

8 Global SPM Variables

For communication via OPC, the following variables are available

BOOL R Digital output 1 X8

BOOL R Digital output 2 X9

BOOL R Digital output 3 X10

BOOL R Digital input 1 X0

BOOL R Digital input 2 X1

BOOL R Digital input 3 X2

BOOL R Output limit 1 X16

BOOL R Output limit 2 X17

BOOL R Output limit 3 X18

BOOL R ADC error X32

BOOL R Above Max X33

BOOL R Overload, above (Max + plus the range that is still permissible) X34

BOOL R Below zero X35

BOOL R Zero +/- 1/4 d X36

BOOL R Within the zero setting range X37

BOOL R The weight is stable X38

BOOL R Below zero or above Max X39

BOOL R Load cell measuring signal negative X40

BOOL R Load cell measuring signal > 36 mV X41

BOOL R Internal arithmetic error; CAL data are perhaps faulty X42

BOOL R ADC error, overload X43

BOOL R Command error X48

BOOL R Command active X49

BOOL R Power fail signal X50

BOOL R ADC test active X56

BOOL R Calibration active X57

BOOL R Instrument is tared X58

BOOL R/W Read / write marker bit 1 X64

BOOL R/W Read / write marker bit 2 X65

BOOL R/W Read / write marker bit 3 X66

BOOL W Switch D11 to net weight X72

BOOL W Set the instrument to zero X112

BOOL W Set tare of the instrument X113

BOOL W Reset the tare of the instrument X114

BOOL W Start the ADC test X115

BOOL W Finish the ADC test X116

BOOL W Reset the power fail signal X117

BOOL W Set the fixtare value as tare X118

BOOL W Store the current gross weight in the fixtare memory (D31) X119

BOOL W Start printing X120

BOOL W Reset error X121