User Manual

PHANTOM HARDWARE DESCRIPTION VERSION 0.01
program. Start the application software (HyperTerminal) which
can be found in the following directory.
 Go to Start > Program > Accessories > Communication and
click the HyperTerminal program.
 On the appeared screen assign the name for the current
connection (e.g. “Phantom”) and click OK.
 Then choose the correct COM Port on which the Phantom
unit is connected as well as select the baud rate of (57000
bps, 8 bit, no parity bit, 1 stop bit) and click OK.
 For a detailed description, please, refer to the sepatated
“Phantom_software_2.1.X_manual.pdf” document,
chapter 7.
This confidential document is a property of FALCOM GmbH and may not be copied or circulated without previous permission.
Page 21