Instruction Manual

ManualsBrandsFALCON RIDGE ManualsRear PanelFALCON RIDGE Mule Pro-FX Falcon Ridge Soft Rear Panel

Table Of Contents

2515 Bypass Rd. Flemingsburg, KY 41041

606-845-7439

Instructions for Installation and Care of

Kawasaki Pro FX

Soft Rear Window

KAW-PROFX-RW01

Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.

1. Be sure to read these instructions thoroughly before opening and installing the Kawasaki

Pro FX Soft Rear Window. The installation is best done when the temperature is 70

degrees F. or warmer. The temperature affects the adhesive Velcro, if conditions prevent

installing in warmer weather it helps to store the adhesive Velcro at room temperature

prior to installation.

2. Carefully open the carton and remove the enclosure on a large flat surface that is clean

and free of dirt.

3. Check over the parts included in the carton with the parts list shown below:

Adhesive Velcro Hook Strips:

Rear Window

“ “ “ “ 2 each------------8”

“ “ “ “ 2 each------------10”

“ “ “ “ 1 each------------24”

“ “ “ “ 2 each------------35”

“ “ “ “ 1 each------------64”

1. Begin by placing the 24" adhesive Velcro strip centered on top of the top rear bar that

runs from one side to the other. Then place the two 10" adhesive strips in each side of

the 24" strip leaving a 2" gap between them. The photo below shows how this should

look.

Summary of content (6 pages)

PAGE 1
2515 Bypass Rd. Flemingsburg, KY 41041 606-845-7439 Instructions for Installation and Care of Kawasaki Pro FX Soft Rear Window KAW-PROFX-RW01 Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable. 1. Be sure to read these instructions thoroughly before opening and installing the Kawasaki Pro FX Soft Rear Window. The installation is best done when the temperature is 70 degrees F. or warmer.
PAGE 2
. Next place the two 35" adhesive Velcro strips down the side bars. There is really only one space that this strip can fit and it is just behind the side protection bars and to the outside of the brackets that hold the rear cage panel in place. The photo below shows the proper placement. 3. The bottom of the Rear Window is held in place by the 63" adhesive Velcro strip and the two 6" strips. The 63" strip goes across the bottom on the plastic from one side to the other.
PAGE 3
PAGE 4
Cleaning and Storage Recommendations: 1. Before removing the Falcon Ridge Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll for storage. 2. It is important that the Cab be rolled up for storage rather than folding.
PAGE 5
Return Policy If for any reason you choose to return this product it must be returned within 30 days from date item is received. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product! The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows.
PAGE 6
Warranty To The Owner of this Product: Thank you for purchasing one of Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to defect of the product. Please refer to the return policy in this case for more information.