Instruction Manual

2515 Bypass Road Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of Polaris General and General Crew
Soft Rear Window
PO-GENERAL-RW01
Caution: Do not smoke inside the cab or expose the enclosure to direct flames. Product is FLAMMABLE.
Be sure to read these instructions thoroughly before opening and installing the enclosure. The installation is best
done when ambient temperature is 70°F or warmer. If installed in cold weather, warming the adhesive Velcro
strips before installation is recommended.
1. Carefully open the carton and unroll the enclosure onto a large flat surface that is clean and free of dirt
or other material that may soil or scratch the vinyl window. Check over the parts included in the carton
with the parts list shown below:
Velcro hook strip 1 each 51” long
Velcro hook strips 1 each 46” long
Velcro hook strip 2 each 20” long
Enclosure 1 each
If any parts are damaged or missing, please contact customer service at (606) 845-7439.
2. Begin by installing the 51” adhesive strip along the top of the rear window frame. The adhesive should
be on both sides of the channel. Then install the two 20” strips down the sides. Clean the areas of any
dirt or grease before applying adhesive strips.

Summary of content (3 pages)