RU Series Specification

13
Retrot Re-Lever Kits
Falcon Lock’s mortise lock ”Re-Lever Kits” are a quick, cost-effective solution to meeting ADA requirements. The Retrot Re-Lever Kit
allows installation of our top quality levers without removing the locking unit. Retrots most manufacturer’s mortise knob locks—even
older style cast versions—with a high quality Falcon lever in ten minutes or less.
Three easy steps:
Template
Step 1
Remove knob trim and
cylinder.
Step 2
Insert spindle from kit into hub.
Place enclosed template over
spindle and drill (4) holes.
Step 3
Insert spindles in hubs and springs in both levers.
Position outer trim on door, then through-bolt
inner trim. Reinstall cylinder, if necessary.
Falcon offers:
1. RW Series—Consists of a wrought, Napa style escutcheon with four mounting posts and die cast levers. Because the levers are die cast,
the trim may be used on UL listed openings. Levers available: Avalon, Dane or Quantum.
R E T R O F I T R E - L E V E R K I T S
G E N E R A L I N F O R M AT I O N