X Series Specification

X S E R I E S
G E N E R A L I N F O R M AT I O N
15
How to Order
For correct ordering, and to ensure no delays in shipment of
your order, the following descriptive data must be listed in the
sequence shown. Necessary information can be found in other
parts of this catalog. The example below shows an order for 20
each X locksets in the 301 Privacy function, EG (Elite-Gala) trim
design in a 626 (satin chrome) nish, with 2-3/4” backset latch,
to accommodate doors 1-3/4” thick.
Quantity: Indicate the quantity required.
Catalog Number: Select function number, cylinder type and latch
style from tables in this section.
Trim Design: Indicate letter of knob/rose design. EG = Elite/
Gala; HY = Hana/York. Outside design always proceeds inside
design on split designs.
Finish: When the nish is the same for the outside and inside trim
it is shown once (ex.: 626). Outside nish always precedes inside
nish on split nishes (ex.: 605 x 625).
Latches: 2-3/4” backset standard. 2-3/8” backset available. All
latches are UL listed 3-hour A label.
How to Order Example
Finishes
The latest in modern techniques and equipment are used to apply
the highest quality nish. Extra steps assure durable, consistent
nishes and long useful life.
Although we apply the nest available protective plating and/
or clear powder coating to the surface of our products, these
nishes have limitations and in time may deteriorate either
from exposure to weather, pollution, perspiration, extremes of
Trim Finishes Chart
Description ANSI No. Available on
Bright Brass 605 All Trim
Satin Brass 606 All Trim
Satin Bronze 612 All Trim
Satin Bronze Oil Rubbed 613 All Trim
Bright Chrome 625 All Trim
Satin Chrome 626 All Trim
Satin Stainless Steel 630 Troy Knobs Only
Strikes: 4-7/8” x 1-1/4” ANSI strike standard. Optional T strike
or Full Lip strikes available. See page 12.
Cylinder Type: Cylinder type: 6-pin standard. For 7 pin add
PD7 to product catalog numbers (eg. X511PD7 HAN). 7 pin
conventional cylinders are available in Hana knob style only.
Door Hand: Locks are eld reversible. Please specify handing
on all keyed locks so that cylinders can be assembled in the
upright position.
Keying Detail: We suggest using the standard terms developed
by DHI (Door and Hardware Institute).
Example: AA1–Grand Master keyed, Master keyed, change key 1.
Interchangeable Core: To order product capable of accepting an
interchangeable core, add sufces from the keying table to the
function number, preceding the latch style. Example: X511HD will
be supplied with SFIC keyed construction core.
Keyways: “G” is standard on regular cylinders, “A” is standard on
interchangeable cores. Other keyways available.
Additional keys: Note the total number of keys required.
Large bow keys: Add “with large bow keys” under
additional details.
climate, frequency of use or other factors. Deterioration of these
nishes is, therefore, not a defect, but a normal process which is
unavoidable. Our company cannot accept responsibility for nish
deterioration in these circumstances; therefore, the nishes cannot
be guaranteed. These products will not be renished or replaced
under our warranty should deterioration of nishes occur.
Line Item Qty. Product Outside Inside Hand Latch Strike
Door
Thickness
EXT DIM
Additional Details/
Keying
DES FIN DES FIN
1 20 X301S EG 626 LHR 98535 5185 1-3/4”
With 012191-003-70
dust box