Installation and Operation Guide

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas supplies before servicing. Check appliance is safe when you have nished.
40
5.6 To Remove the Left-hand Oven Bottom and Top
Elements
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Bottom Element
Pull the cooker forward to access the cover boxes at
the rear of the unit. Remove the xings that secure the
cover and lift it clear.
Remove the 2 screws ‘A’ and allow the plate to drop
down (Fig.9-8). Remove the 2 screws ‘B’ lower the upper
plate and remove through the slot in the range back
(Fig.9-8). Undo the terminal connections, noting their
positions. Withdraw the element.
Remove the element screws and withdraw element.
Replace the element and re-assemble parts in reverse
order.
Top Element
Open the left-hand oven door and undo the xings that
secure the heat shield. Remove the top element bracket
xings and withdraw the element.
Replace the element and reassemble parts in reverse
order. Check that the oven operates satisfactorily.
6 Doors
6.1 To Remove the Grill Door
Remove the left-hand side panel (see 1.3). Remove
the plinth (4 screws) and the central vertical cover
(5screws). Remove the 2 countersunk screws (1 each
side) securing the grill hinge arms to the front of the
grill chamber.
Note: The arms are spring tensioned. Carefully remove
the grill door. Retain the gaskets.
Reassemble in the reverse order, making sure that the
gasket is tted between the hinge arm and the front of
the grill chamber.
6.2 To Replace the Main Oven Door
Open the oven door. Support the door and loosen the
2 screws securing the upper hinge and gasket to the
cooker front (Fig.9-9).

The door is heavy, so take care.
Support the door and remove the screw nearest the
hinge pin (Fig.9-10). Swing the hinge up and away from
the door hinge pin. Lift the door away from the lower
hinge and remove.
Reassemble in reverse order.
6.3 To Adjust the Main Oven Door Angle
The bottom hinge of either oven door can be adjusted
to alter the angle of the door (Fig.9-11). Loosen the
bottom hinge xing screws and use the notch and a at
bladed screwdriver to move the position of the hinge to
set the hinge position (Fig.9-12).
Retighten the hinge screws.
ArtNo.320-0006 Oven door hinge adjustment 1
Fig.9-12
Eect of hinge adjustment – exagerrated for clarity
ArtNo.320-0001 Door hinges

ArtNo.320-0001 Door hinges

Fig.9-9 Fig.9-10
ArtNo.320-0007 Oven door hinge adjustment 2
Fig.9-11
Centreline of hinge pin
Oven door omitted for clarity
ArtNo.322-0002 Oven bottom element access
A
B B
Fig.9-8