User's Manual

INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
34
Final Fitting and Checks
Note: The clock must be set before the ovens will work. See
‘The Clock’ section for instructions on setting the time of day
Hotplate Check
Check each burner in turn (refer to the “Hotplate Burners” on
page 7 of the instructions).
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Set the clock as described earlier in the instructions, and then
turn on the ovens. Check that the oven fans start to turn and
that the ovens start to heat up.
Note: The oven light bulb is not included in the guarantee.
Turn o the oven.
Fitting the Handles and Handrail
Remove the 4 mm Allen screws from the doors (Fig. 10.19).
Fit the door handles and secure using the 4 mm screws.
n
The handles should be above the xings.
Remove the 4 mm Allen screws from the top corners of the
fascia (Fig. 10.20). Fit the front handrail in position and
secure using the 4 mm screws.
Fitting the Plinth
Fit the inner plinth to the bottom front of the cooker using
the 4 screws provided (Fig. 10.21).
Fit the outer plinth (2 screws, 1 each end) to the inner plinth.
The height of the outer plinth can be adjusted by sliding it up
or down via the slotted hole (Fig. 10.22).
Fitting the Splashback
Position the splashback on the rear of the hotplate and secure
with the screws supplied.
Customer Care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
Outer plinth
Outer plinth xing screw
Inner plinth
Fig. 10.22
ArtNo.215-0026 - Handle gaskets fixed
Fig. 10.19
Art No 215-0028 - Handrail fascia fixings
Fig. 10.20
Fig. 10.21