User Manual
Table Of Contents
- 1. Before You Start...
- 2. Cooker Overview
- 3. Using the Glide-out Grill™
- 4. Cooking tips
- 5. Cooking Table
- 6. Cleaning your cooker
- 7. Troubleshooting
- 8. Service and Spares
- 9. Installation
- Location of cooker
- Conversion
- Positioning the Range
- Moving the cooker
- Lowering the two rear rollers
- Completing the move
- Levelling
- Repositioning the cooker following connection
- Gas Connection
- Natural Gas
- Propane
- Pressure Testing
- Pressure Testing
- Electrical Connection
- Connection in New Zealand
- Fixed Wiring
- Repositioning the cooker following connection
- 10. Final Fitting
- 11. Conversion to LP Gas
- 12. Servicing
- 13. Circuit Diagram
- 14. Technical Data
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have nished.
33
Set the Governor
Unscrew the governor’s brass top. In the base of the brass top
is a plastic snap-in converter device (Fig. 11.5). To convert the
governor, snap the device out of the top and ret it the other
way round. The snap-in converter device is marked to show
the gas for which it is set (Fig. 11.6).
Make sure the device is secure in the top cap and ret the cap
to the governor.
Pressure Testing
The pressure test point is accessible on the inlet pipe at the
rear. Remove the test nipple screw and t a pressure gauge to
the test point. Turn on and light two of the hotplate burners.
For Propane X cookers the pressure should be 2.54 kPa.
n
Check the appliance is gas sound.
n
Check operation of all the burners.
Affix Label
Stick the appropriate gas label over the natural gas part of the
appliance data label.
ArtNo.102-0007 - Maxitrol converter device positions
ArtNo.103-0006 - Maxitrol cap & converter
Nut
Snap-in converter device
Fig. 11.5
Fig. 11.6